Cub Cadet Z Force S 54

21se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s
Lubrication
WARNING! 

brake, stop engine and remove key to prevent
unintended starting.
Front Wheels
Each of the front wheel spindles and rims is equipped with a grease

applied with a grease gun after every 25 hours of tractor operation.
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
Deck Spindle


purpose lithium grease. Using a grease gun, apply two strokes
(minimum) or sufficient grease to the spindle shaft.
Attach the hose coupler to the water port on your decks 

Turn the water on.4.
5.

position.
6.
7.
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
8.
position.


Turn the water off and detach the hose coupler from the 

 


deck running for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly dry.
Grease
Fittings
Figure 6-3
Grease Fitting
Figure 6-4
Nozzle Adapter
Adapter Lock Collar
Deck Wash Nozzle
Figure 6-2