17Section 5 — operation
8. Allow the engine to run for a few minutes at mid-throttle
before putting the engine under load.
indicator light or oil pressure light come on, immediately
stop the engine. Have the tractor inspected by your Cub
Cadet dealer.
Cold Weather Starting
When starting the engine at temperatures near or below
freezing, ensure the correct viscosity motor oil is used in the
engine and the battery is fully charged. Start the engine as
follows:
has much more starting capacity than a cold battery.
2. Use fresh winter grade fuel. Winter grade gasoline has
higher volatility to improve starting. Do not use gasoline
left over from summer.
Follow the previous instruction for Starting the Engine.
Using Jumper Cables To Start Engine
WARNING!
produce explosive gasses. Make certain the area is
well ventilated, wear gloves and eye protection, and
avoid sparks or flames near the battery.
If the battery charge is not sufficient to crank the engine,
recharge the battery. If a battery charger is unavailable and
the tractor must be started, the aid of a booster battery will be
necessary. Connect the booster battery as follows:
Connect the end of one cable to the disabled tractor
2. Connect one end of the other cable to the booster
that cable to the frame of the disabled tractor, as far from
the battery as possible.
Start the disabled tractor following the normal starting
instructions previously provided; then disconnect
the jumper cables in the exact reverse order of their
connection.
4.
as soon as possible to eliminate the need for jump starting.
Stopping the Engine
2. Engage the parking brake.
position and
allow the engine to idle for about one minute.
4.
key from the ignition switch.
NOTE: Always remove the key from the ignition switch to prevent
accidental starting or battery discharge if the equipment is left
unattended.
Driving The Tractor
WARNING! Avoid sudden starts, excessive speed
and sudden stops.
Release the parking brake. Move the throttle lever into the
FAST position.
2.
Travel in Reverse
Travel Forward
Figure 5-3
To stop or slow down the tractor, take your foot off of the
forward or reverse drive pedal. To lock the parking brake,
pull the lever fully rearward and to the right; then into the
disengage the parking brake.
NOTE: The forward and reverse pedals must not be used when
the brake is partially engaged. When the brake is locked in the
back then the brakes are engaged but so is the drive belt so
transmission damage will occur if you push forward or reverse.
4. To travel in REVERSE, check that the area behind is clear
your heel) until the desired speed is achieved. See Figure
CAUTION:
direction of travel when the tractor is in motion.
Always bring the tractor to a complete stop before
moving the tractor from forward to reverse or vice
versa.
WARNING! Do not leave the seat of the tractor
parking brake. If leaving the tractor unattended, also
turn the engine off and remove the ignition key.
To Next Page
Loading...
Need help?
General
