Cubii JR1+ - Console Profile Reset; Manual Data Reset; Distance Metric Toggle; Manually Set a Smart Reset

12
IV. Using Your Cubii JR1+
Console Prole Reset
User 1 and User 2 proles can be reset from the console. Simply
select the relevant user prole then hold the User button for 3
seconds then release the button to complete the prole reset.
Resetting the user prole from the built-in console erases any data
stored for that prole and also delinks the prole from the app. The
prole can be easily re-established in the app if needed.
Manual Data Reset
Manually reset data for any prole on the console (User 1, User
2 or Guest) by selecting the relevant prole (see User Button
section above) and then holding the Mode button for 3 seconds
then release the button to complete the prole reset. This action
resets any data displayed on the screen for the selected prole.
Distance Metric Toggle
To switch from miles to kilometers (or kilometers to miles), use the
MODE button to select the Distance metric. Then, hold the MODE
button for 6 seconds. If you are using the Cubii app, this update will
also be reected there.
Manually Set a “Smart Reset”
If you do not pair your elliptical to the Cubii app, but still want
your console to reset each evening at midnight, follow the
instructions below to set the clock to the current time:
1. Simultaneously press the USER and MODE buttons 3 times in a
row to reset the clock. It should ash “00:00”.
2. Press the USER button to cycle through hours until you get to
the right hour. Note that the clock uses military time.
3. Press the MODE button to cycle through minutes until you get
to the right minute.