16
IV. Using Your Cubii JR1+
Resistance Level
The Cubii app will automatically retrieve the resistance level from
the elliptical. However, please note that the app CANNOT update
the resistance on the elliptical itself. The resistance is managed by
the elliptical and the app reads that information.
User 1, User 2 and Guest Proles
Your Cubii elliptical offers multiple user proles on the console
in the event that you plan on sharing your device. This means
that you can easily keep track of your data separately by simply
switching proles, so User 1, User 2 and Guest proles can
all have different sets of data. The prole on the console also
corresponds to the app. You will be prompted to select a prole
in the app when you set up your account and connect to the
elliptical for the rst time.
If you have selected the User 1 prole, then someone else can
become User 2 (and vice versa). From that point forward, the app
will check to make sure the console is toggled to the correct user
prole and will automatically send a command to the elliptical to
update the console prole as needed.
You will always have the option to proceed as Guest. Anyone can
connect to the elliptical as Guest. Any user connected as Guest
will have the data from the elliptical synced to their app.
NOTE – If you have opted to set your app as User 1 or User 2 but
decide to exercise without the app actively connected, then make
sure that the console is toggled onto the correct user prole.
Without an active connection with the app, the data will be
attributed to whichever User prole is selected on the console.
To Next Page
Loading...
