-6-
Assemble front bumper
Insert the front bumper bar into the openings on the front of the chassis.
You should hear a “click”.
Remove the front bumper by pressing the buttons on two sides.
5
Harness & Buckle
Note:
Thread the shoulder straps through
the loops to reduce the
shoulder strap height if required.
To fasten the waist harness:
Insert both buckle clips into each side
of the buckle until a “Click!”
is audible.
To release the harness:
Squeeze the buckles and pull apart.
To adjust the buckle:
Adjust the shoulder straps by moving
the slides as shown
insertion
6
2255279/3060827
To Next Page
Loading...
