Cuisinart CBT700E - Control Panel

17
appliance correctly for proper operation.
C. Control Panel
1.
2.
3.
4.
5.
6.
7. 8.
9.
1. On/O
2. HIGH: Beat
3. Display of preparation time
4. LOW: Mix
5. Pulse
6. Smoothie: Fruit juices & smoothies
7. Crushed ice
8. Soups & sauces: Liquid preparations
9. Purée: Thick preparations
1
and speed settings
• Press . A  ashing light will come on indicating
that the unit is in ‘standby’ mode.
• Depending on the speed desired, press or
once to start the appliance. The corresponding light
will come on while the blender is running. A timer will
also start and the operation time will appear in the
appliance’s digital display.
N.B. The preparation time is programmed for 1
minute
• It is possible to change the speed while the blender is
running. Simply press on the desired button.
• To stop the blender while it is running, press the
button that corresponds to the speed being used.
The timer will stop counting down and will start again
when another speed is selected.
• To stop the blender press
. The timer will stop
counting down and the display is reset to ‘0:00’ When
the blender is started again and a speed is selected,
the timer starts counting down again from 0:00. Press
. once. The  ashing light located next to
goes out automatically which indicates the blender
has been turned o .
N.B. When the jar is removed from the base, the
appliance shuts o and the timer is reset to 0:00.
2. The
button
This function lets you blend using short bursts for more
precise
results.
• To use this function, press . A light around the
button will begin to  ash which indicates that the
appliance is in ‘standby’ mode. Press , the light
around the button will start to  ash which indicates
this function is activated.
• Press and hold the button corresponding to the speed
desired , the unit will stop operation once the speed
desired button is released. Repeat as often as desired.
N.B. The timer indicates the duration during which
the is held down. The timer stops counting
down when the is released. The can be
used with
, , , .
• The pulses should be very short bursts. Pause the
blending long enough to allow the blade to stop
turning.
• The can be used to chop larger pieces of food
or to check the texture of a preparation. This function
is particularly useful when you want to blend with
precision.