7
BEFORE BREWING YOUR
FIRST POT OF COFFEE
Rinsing your coffeemaker: During the
manufacturing process, dust can get trapped in
the unit. We recommend flushing out the
system before brewing your first pot of coffee.
Simply fill the reservoir, power on the unit, and
follow steps 1, 3 and 5 on page 8 under
MAKING COFFEE. Do not add coffee!
PROGRAMMING YOUR
COFFEEMAKER
SETTING THE CLOCK
When the coffeemaker is plugged in, 12:00 will
flash in the display for 10 seconds, indicating
the unit is in Clock Set mode. If 12:00 stops
flashing, simply press and hold Hour or Minute
button to return to flashing Clock Set mode.
Setting Hours and Minutes
Press either button to select the desired time.
Hold buttons down to scroll through the digits
quickly, or press and release to advance one
digit at a time. Be sure the PM indicator is on
if setting a PM time.
SETTING THE AUTO ON TIME
1. Press and hold the Prog/Auto On button
for 2 seconds.
The digital display will flash the default
(12:00) or previously selected time. Follow
directions under SETTING THE CLOCK
(above) to program your start-brew time.
Five seconds after finishing, the unit will
automatically exit Auto On Setup mode
and the indicator light will illuminate,
letting you know Auto On is activated.
NOTE: To exit Auto On Setup mode, you can
also just press Auto On button again.
2. To activate Auto On using previously
selected time:
Press the Prog/Auto On button. Previously
set time will appear and indicator will light
up. Display will return to clock setting.
3. To deactivate Auto On:
Press illuminated Auto On button; light will
go off, indicating mode is turned off.
Charcoal Water Filter
Your coffeemaker comes with a charcoal
water filter that eliminates chlorine, bad
tastes and odours from tap water.
Inserting the Water Filter
• Remove the filter from polybag and soak
it, fully immersed, in cold tap water for
15 minutes.
• Lift the water filter holder out of the water
reservoir.
• Press down on the filter compartment and
pull toward you to open.
• Place filter into the holder and snap it
closed. Be careful – improper placement
can tear the filter skin.
• Flush filter by running
cold tap water through
holes in bottom of
compartment for
10 seconds.
• Allow the filter to drain
completely.
•
Slide the water filter holder
back into the channel in the
water reservoir, pushing it
down to the base of the unit.
NOTE: We recommend
changing the water filter
every 60 days or after 60
uses, and more often if
you have hard water.
Replacement filters can
be purchased in stores, by
calling Cuisinart Customer
Service, or at
www.cuisinart.ca
To Next Page
Loading...
Need help?
General
