Figure 5
12. Place a small amount of O-ring lubricant on surface of filter housing O-ring. Install O-ring into
housing.
TO SANITIZE THE SYSTEM: Complete Steps 13-33.
TO INSTALL FILTERS: Complete Steps 20-33.
CAUTION: Wear safety glasses while performing this procedure.
CAUTION: Read “WARNINGS” information on bleach container before using con-
tents. Handle sanitizing solution carefully. Avoid contact with unprotected areas.
13. Mix sanitizing solution of 1.5 ml (1/3 teaspoon) of household bleach and 3.8 L (1 gallon) of
clean, potable water in the bucket. Mix solution well.
Note: Excessive concentrations of bleach (sodium hypochlorite) may damage plastic and rub -
ber components. Rinse all parts that contact bleach thoroughly with clean potable water.
14. Add 236 ml (one cup or 8 oz.) of sanitizing solution to each filter housing and install
them onto the manifold (do not install filters or membrane at this time). Tighten
each filter housing by hand only.
12
To Next Page
Loading...
Need help?
General
