4 | JetSort
®
1606 interface with JetScan or JetCount | Connecting Your JetSort
Connecting Your JetSort
Program JetSort to Operate with JetScan or JetCount
To set bill count and print features:
1. From the SETUP menu, advance to the BILCNT menu.
2. Press PRINT to move the cursor to the bottom menu line.
3. Press TOTALS or DENOM to scroll to the desired setting:
Auto – Note totals appear after each sub-batch is ended.
Dmnd – Note totals appear only when MEDIA is pressed.
4. Press START S/BAT to move the cursor to the Prnt option.
5. Press TOTALS or DENOM to scroll to the desired setting:
6. All – prints totals by denomination of processed currency.
7. Total – prints total of processed currency.
8. Press CLEAR to exit or continue to the next menu option by pressing PRINT, then START S/BAT.
9. Press PRINT to exit OPTIONS menu.
10. Press START S/BAT to scroll to the PORT 1 menu.
Install Software Kit 2 and Kit 4 before connecting the JetScan (model 4062 and higher)
or JetCount (model 4020 or higher).
JetScan and JetCount Bilcnt must be set to AUTO or DEMND.
To Next Page
Loading...
