These two screens will sequentially flash:
Return hopper to the operating position.
.
Rerun all notes that were in the top hopper and bottom stacker at the time of
the jam.
Universal JetScan cannot
recognize the denomination of a
note and has stopped. This
no call note is the top note in
the stacker. This note has not
been included in the count.
Inspect the top note in the stacker to determine the correct denomination.
Do not
remove all notes from the stacker.
Then either:
• Leave the note in the stacker and press the appropriate
denomination
value key (VAL key)
to add the note to the total.
• Reprocess the note by returning it to the hopper and pressing
.
Denomination Sub Total Batch Count
Universal JetScan has identified
a note that is incorrectly
oriented.
Correctly orient the note and return it to the hopper and press Start.
© 2014 Cummins-Allison Corp.