Cupra BORN - Page 125

Visibility
124
1)
Regulation in right-hand drive vehicles is symmetrical
/
Adjusting the exterior mirrors
Fig. 113 Detail of the driver door: control
for the exterior mirror.
Turn the control to the corresponding posi-
tion. The symbol lights up:
Moving the control to the desired position
adjusts the mirrors on the driver's side ( ,
left) and on the passenger's side ( , right)
in the desired direction.
The exterior mirror heating turns on. The
heating only operates when the ambient
temperature is below +20°C (+68°F), and
initially at full power. After approx. 2 mi-
nutes, its heat depends on the ambient
temperature.
Folding the mirrors ››› .
The exterior mirror cannot be adjusted
and all functions are deactivated.
Activating exterior mirror functions
The following exterior mirror functions can
be activated and deactivated in the vehicle
settings menu of the infotainment system
››› page 36.
Synchronized regulation of the exterior mir-
rors
The synchronised mirror setting simultane-
ously adjusts the right hand exterior mirror
when the left mirror is adjusted
•
Turn the control to position
1 )
.
•
Adjust the left-hand exterior mirror. The
right exterior mirror will be adjusted at the
same time (synchronised).
•
If necessary, correct the setting of the right
hand mirror: turn the control to position
1)
.
Fold the rearview mirrors when locking the
vehicle
When the vehicle is locked or unlocked from
the outside, the exterior mirrors can be fol-
ded in or out automatically, depending on the
equipment. For this purpose, the rotary control
has to be in position
, , , or .
If the rotary control of the electric exterior
mirrors is in position , the exterior mirrors
remain folded.
Saving and activating the passenger side ex-
terior mirror setting for reversing
•
Unlock the vehicle with the key to which you
wish to assign the setting.
•
Select reverse gear.
•
Adjust the front passenger exterior mirror so
that you can see, for example, the kerb edge.
•
Move the gearshift to the neutral position.
•
Switch the ignition o.
•
The mirror's set position is saved and as-
signed to the key.
Activating the passenger side exterior mirror
settings for reversing
•
Turn the exterior mirror control knob to posi-
tion
1 )
.
•
Engage reverse gear with the ignition
switched on. The right-hand exterior rear-view
mirror will move to the saved position.
The passenger side exterior mirror leaves the
saved reversing position when the vehicle is
travelling faster than approx. 15 km/h (9 mph),
or if the control is turned from position to
another position.