Cupra BORN - General Instructions for Use

Infotainment systemGeneral instructions for use
231
General instructions for
use
Operating indications
•
The infotainment needs a few seconds for
the complete start-up of the system and dur-
ing that time it does not react to inputs. Only
the image of the rear view camera system can
be displayed during system start-up.
•
The display of all indications and the execu-
tion of functions only takes place once the in-
fotainment system has nished booting. The
duration of the system booting depends on
the number of infotainment functions and may
take longer than normal in the event of very
high or very low temperatures.
•
When using the infotainment system and
corresponding accessories, e.g., headphones,
bear in mind country-specic regulations and
legal provisions.
•
The online navigation, online voice com-
mand and Internet Radio functions (among
others) require the activation of CUPRA CON-
NECT Gen4 services (linked to the CUPRA
CONNECT PLUS pack) and an Internet con-
nection for the vehicle. The data transmission
must not be limited to perform the functions.
•
To use the infotainment system, simply lightly
press a button or touch the screen.
•
For the correct operation of the infotain-
ment system it is important that it is switched
on and that, if necessary, the time and date of
the vehicle are set correctly.
•
If a function button is missing on the screen,
it is not a device defect, but corresponds to the
specic equipment of the country or version.
•
Some infotainment functions can only be se-
lected when the vehicle is at a standstill. In
some countries, the gear selector must also be
in parking position P or neutral N. This is not
a malfunction, but is due to compliance with
legal requirements.
•
Restrictions on the use of devices using
Bluetooth® technology may apply in some
countries. For further information, contact the
local authorities.
•
If you disconnect the 12 volt battery, turn on
the ignition before restarting the infotainment
system.
•
If the setup is changed, this may change the
display on the screen and in some cases, the
infotainment system may behave in a manner
dierent to that described in this instruction
manual.
•
When the drive system is switched o and
the charge level of the vehicle’s 12 V battery is
low, the infotainment system switches o auto-
matically.
•
Ensure that any repairs or modications that
need to be carried out on the infotainment
system are carried out by a specialised work-
shop. To do so, CUPRA recommends going to a
specialised CUPRA dealer or any SEAT dealer-
ship.
•
Using a mobile phone device inside the vehi-
cle may cause noise in the speakers.
•
On vehicles with park assist, the audio
source volume is automatically lowered when
reverse gear is selected. The volume reduction
can be adjusted.
•
Information about the included software and
the license conditions can be found in Set-
tings > Copyright
.
•
When selling or lending the vehicle, make
sure that all saved data, les and settings have
been deleted and, if necessary, external audio
sources and data media have been removed.
Remember to also restore the factory settings
to unlink your CUPRA ID username from the
vehicle, as well as your CUPRA CONNECT
Gen4 pack.
Note
You will nd more information and tips for
using the infotainment system in the
Help
menu.
HOME screen
In the control and display unit you can set
up the views and representation on the home
screen or use the factory setting templates.