Cupra BORN - Page 252

Infotainment systemNavigation
251
Note
If the address details of a contact are ob-
solete, the route guidance will nevertheless
take you to the registered address. Check
that the contact address is updated.
Add stops for automatic charging
To add stops for automatic charging, under
route options activate the automatic charging
station planning as required along the route.
There is a limited number of waypoints in the
route calculation planning:
•
Maximum of 5 charging stops calculated au-
tomatically by the system.
•
Maximum of 3 waypoints determined and set
by the user.
•
Any combination of the two that respects
the aforementioned maximums.
If the route requires the calculation of more
stops than are permitted, this calculation
would be cancelled.
Note
Getting optimal results when calculating
routes with automatic charging points de-
pends on the availability of charging points
stored in the navigation data.
In settings you can specify the desired pay-
ment mode for the charging stations. Depend-
ing on your selection and the available data,
suitable charging stations are displayed on the
map and programmed into the route.
The adjustable maximum charging limit for the
vehicle can be adjusted in the Vehicle main
menu.
Select alternative charging stations
For planned routes, instead of automatically
planned charging stations, you can select al-
ternative charging stations along the route.
1. Enter or select the desired destination.
2. Press Start.
3. Open the route details.
4. In the route details, press on a planned
charging station. Details of the planned
charging station are displayed.
5. Press Show more charging stations.
The locations of other charging stations in
the vicinity are shown on the map.
6. On the map or list, press an alternative
charging station in the vicinity. Details are
displayed of the alternative charging sta-
tion.
7. Press Charge here.
OR: press Add as stopover. The previously
programmed charging station is replaced
by the newly selected charging station and
the route is adapted.
Note
If you select Add as stopover, the selec-
ted charging station is kept if the route is
changed.
Traic information
The infotainment system receives detailed
traic information automatically if the Internet
connection is established. This information is
shown with symbols and highlighting the road
network in colour on the map.
Traic incidents
Traic incidents, for example, traic jams or
congested traic, are shown on the navigation
map using symbols.
With an active route guidance, traic incidents
that are on the current route are shown in
the route details. Such traic incidents can be
avoided
›››
page 252, Function descriptions.
Hazard information
Hazard information is shown on the navigation
map with symbols in the same way as traic
incidents. In this case, the source of this infor-
mation is another vehicle that has detected
the hazard and has uploaded the information
to the service provider.
The hazards shown are: accident, broken down
vehicle and slippery road surface.