Current eFlux User Manual

Programming Guide
Press the Main ON/OFF key to turn all of the pumps and pump display ON or OFF. When
pumps are on, LEDs on display will illuminate. If all pumps are turned off, all LEDs on display will
be off.
To individually turn each pump ON/OFF, hold the designated Pump Key for 5
seconds. Pump will turn ON or OFF.
To Lock settings and IR remote communication, press Lock
key and hold for 5 seconds, the LED over LCK on the pump
display will turn green.
To unlock settings and IR remote communication, press Lock
key again for 5 seconds, the LED over LCK on the pump
display will turn off. The wireless remote will not operate and
communicate with the HUB and LED display.
To set all pumps into feeding mode, press the FEED Mode key .
All pumps within the LOOP network will go into idle speed for 10 minutes.
After 10 minutes, all pumps will ramp back into their previously programmed
flow mode.
Operational Flow Modes
There are three modes of water flow available for Pumps 1 and 2;Stream/Steady, Surge/Gyre and
Wave/Pulse. Note that Pump 3 is designated as a circulation pump and can only be programmed
in Stream/Steady Flow Mode.
!
"
#
LOCK
LOCK
LED ON = Locked
LED OFF = Unlocked
FEED
TIME
STREAM/STEADY MODE
0
100%
50%
When a pump is in Stream/Steady mode, the pump will constantly circulate
water at the programmed speed.
Flow
Flow rate is adjustable from
0-100% in 10% increments by
pressing:
FLOW
FLOW
Step 1: Turning pumps ON/OFF
Step 2: Turning individual pumps ON/OFF
Step 3: LOCK / unlock remote
Step 4: FEED Mode
Step 5: Programming Flow Modes
eFlux Wave Pump Kit
Page 6
Display remains same
during FEED Mode

Current eFlux Specifications

General

Brand	Current
Model	eFlux
Category	Water Pump
Language	English