Currys Essentials CFSEWH14 - Adjusting the Feet; Moving the Cooker; Stability Bracket

16
Adjusting the Feet
Your oven has 2 adjustable feet at the front and 2 at the back. When the oven is placed where it will be used,
check if the oven is level. If it is not level, you can adjust the feet by turning the feet if required. It is possible to raise
the appliance a maximum of 10 mm using the feet. DO NOT move the appliance by dragging; lift it into place.
Using the tted adjustable feet is MANDATORY. For safety reasons
and to ensure adequate ventilation, the cooker chassis MUST NOT
sit directly on the oor, a plinth, or other support surface.
1. Open the front ap to access the adjustable feet.
2. Your cooker has 4 adjustable feet, 2 at the front and
2 at the rear of the cooker.
3. Use a at blade screwdriver to adjust the feet. Turn clockwise
to raise the cooker. Turn anti-clockwise to lower the cooker.
4. Close the ap once level.
Moving the Cooker
• Two people must always raise the cooker, as shown, to prevent
damaging the adjustable feet.
• Do not lift the cooker by the door handles.
• DO NOT DRAG the cooker. Lift the feet clear of the oor.
Stability Bracket
The supplied stability bracket or a recognized cooker stability device must be tted to the back of the cooker
as shown.
70mm
BA
A = 100mm B = 135mm
Cooker Wall
* All images are for indication only; please refer to your individual unit for actual item.
CFSEWH14/SV14_IB.indd 16 31/03/2015 15:54