PAGE 4
Disconnect Indication
Should a trailer disconnect occur, either unplugged or wiring
failure, the status LED will glow steady red. It will remain red
for approximately 10 minutes or until the connection is restored.
If the disconnection was not a result of intentionally unplugging
the trailer, check and repair wiring to the trailer brake system.
Output Control
The output control establishes the maximum
amount of power available to the trailer brakes.
As the output control is moved to the right, more power will be available
to the brakes when the brake pedal is pressed or the manual control is used.
The output control should be adjusted during initial setup, when trailer load
changes, when different trailers are used or to adjust for a change in road conditions.
The output setting is shown on the display when a trailer is connected
and the brake pedal is pressed or when the manual control lever is actuated.
The output setting is shown as one to eight green bars.
To Next Page
Loading...
Need help?
General