PAGE 5
Sync Control
The sync control is located on the left side of the brake control unit and is
responsible for adjusting trailer brake aggressiveness. The trailer brakes become
more aggressive as the switch is moved toward the front of the tow vehicle.
The sync adjustment has no effect on the manual control. The sync control
should be adjusted for individual driver preference or changing road conditions.
The sync setting is shown on the display when a trailer is connected, the brake pedal
is pressed or when the manual control lever is activated and the sync control is moved.
The sync setting is shown as one to eight bars with a ashing green status LED.
Manual Control
The manual control lever is located on the front left of the brake control unit.
It only applies to the trailer brakes. Manual control is used during initial setup
and in situations where a slow reduction in speed is desirable.
When the manual control is pushed to the right, the control begins to apply
the trailer brakes. The further to the right it is pushed the harder the brakes
are applied until the maximum set by the output control is reached.
The output setting will be shown on the display and can be adjusted when using the
manual control. The manual control activates the tow vehicle and trailer stoplights.
To Next Page
Loading...
Need help?
General