PAGE 9
1. Determine a suitable mounting location.
Mount the unit securely to a solid surface where it is easily accessible to the driver.
The area behind the mounting location must be clear to prevent damage while drilling.
2. Hold the mounting bracket in the position selected
and mark hole locations through the slots in the bracket.
3. Using a 1/8" diameter bit, drill holes in the marked locations.
4. With a philips screwdriver, secure the bracket in place using the two
screws provided. Be careful not to strip the holes by over-tightening.
5. Mount the brake control unit in the bracket using the two
screws provided, as shown in the illustration on page 8.
Wiring
NOTE: Removal of factory supplied quick plug may void warranty.
Most pick-ups and utility vehicles are equipped with a plug from
the factory that allows quick brake control installation. Check the
owner's manual for plug availability, location and installation.
If the mating plug supplied with the vehicle is no longer available, a CURT
quick plug can be used. See the CURT catalog for application information.
For tow vehicles not equipped with a factory brake control plug,
we suggest the CURT brake control wiring kit, part# 51500.
To Next Page
Loading...
Need help?
General