CAB INSTALLATION
10 of 35
Fig. 3.1 (Remove hand screws and ROPS Bolt)
Fig. 3.3 (Remove upper bolt)
Remove
Remove
Remove
Fig. 3.6 (Tilt the ROPS)
Fig. 3.4 (Install Left ROPS Mount)
Bolt Only
ROPS
Mount
Step 3: (Install ROPS Mounts)
3.1 See fig. 3.1. Remove the left and right hand
tension screws and clips on the ROPS and
discard.
3.2 Remove the ROPS pin and bolt from the left side
and discard. See fig. 3.1. Leave the right side
installed at this time.
3.3 See fig. 3.3. Remove the upper bolt on the cross
hose protector as shown and discard.
3.4 See fig. 3.4. Install the left ROPS mount using the
following hardware. The large bolt in the pivot
hole should be tightened just enough so that the
ROPS can still tilt without damaging the paint.
The large bolt in the hole where the pin was
removed, should be installed through the bracket,
but no nut is installed at this time. Tighten the
smaller M8 bolt.
Hardware Used Qty
M16x2x80mm Hex Head Bolt 2
M16x30 Steel Flat Washer 3
M16x2 Locknut 1
M8x1.25x30mm Flange Bolt 1
3.5 Repeat steps 3.2, 3.3, and 3.4 for the right side.
3.6 See fig. 3.6. Remove the lower M16 bolts from the
previous steps and tilt the ROPS back and re-use
the bolts to pin in the tilted position. Be careful not
to damage the engine hood if it is in the open
position. The nuts on the lower bolts will be
installed in a later step.
M16 Bolts
To Next Page
Loading...