CAB INSTALLATION
4 of 35
Fig. 1.4 (Unbolt Compressor)
Step 1: (Vehicle Prep)
1.1 Park vehicle in a location accessible by an
overhead hoist.
1.2 Disconnect the negative battery terminal.
1.3 See fig. 1.3. Remove the bolt from the battery
clamp and replace with a longer one from the
supplied hardware kit and re-use the nut, but do
not re-connect the battery.
Hardware Used Qty
5/16x1-1/4 Square Head Bolt 1
1.4 See fig. 1.4. Remove and discard the 3 bolts and
nuts securing the compressor bracket to the base
of the shipping mount and cut any zip ties holding
the hoses and wire harness to the shipping mount.
Support the compressor using a bungee cord or
rope. Do not ever use the hoses to support the
compressor or damage may occur.
1.5 Remove the Compressor mounting bracket from
the compressor. Leave the compressor
tensioning bracket attached to the compressor.
Save the 3 bolts for reuse.
Fig. 1.3 (Replace Negative Battery Bolt)
Replace
To Next Page
Loading...