CAB INSTALLATION
5 of 35
Fig. 1.6 (Remove bolts)
Remove
Step 1: (Vehicle Prep)
1.6 Remove and discard three bolts from the left side
of the engine as shown in fig. 1.6.
1.7 See fig. 1.7. Remove and reuse two OEM bolts
and install the shroud mounting bracket. Secure
the bottom of the bracket with two M6 bolts and
two M6 nuts.
Hardware Used Qty
M6x1.0x20mm Flange Bolt 2
M6x1.0 Nylock Nut 2
1.8 See fig. 1.8. Install the compressor mounting
bracket behind the alternator wiring. The
alternator wiring does not need to be removed, but
be careful going past with the bracket. Secure
with the hardware listed below.
Hardware Used Qty
M10x1.25x30mm Flange Bolt 3
Note: Ensure there is a gap between the alternator
power wire and the compressor mounting bracket.
If needed, loosen the nut, rotate the wire down,
and re-tighten the nut.
Reuse
M6 Bolts
and Nuts
Fig. 1.7 (Install shroud mounting bracket)
Fig. 1.8 (Install compressor mounting bracket)
M10 Bolts
M10 Bolt
Gap
Loosen and
Rotate if needed
To Next Page
Loading...