Curtis Kubota ZD1211 - Step 2: Dynamo Installation

CAB INSTALLATION
9 of 35
Fig. 2.2a (Replace Tensioner Bracket)
Fig. 2.1 (Remove OEM Dynamo)
Fig. 2.2b (Install replacement Tensioner Bracket)
Step 2: (DYNAMO INSTALLATION)
2.1 See figure 2.1. Remove the OEM dynamo from the
vehicle and discard. Save the hardware for reuse.
2.2 See figures 2.2a and 2.2b. Use a 10mm wrench to
remove the OEM dynamo tensioner bracket and
discard. Reuse the hardware and install the supplied
larger bracket. Do not fully tighten the bolts at this
time.
2.3 See fig. 2.3. Mount the new dynamo in the original
location. Ensure the bolt starts on the engine side
and the washers and nut are on the dynamo side.
Do not fully tighten the hardware at this time.
2.4 Install the belt over the new dynamo pulley.
Ensure the belt is properly running on all pulleys.
See fig. 2.4.
2.5 Install the tensioner bolt. Do not fully tighten at
this time.
2.6 Tighten the 2 tensioner bracket bolts.
2.7 Tension the belt and tighten top dynamo bolt with
a 12mm wrench.
2.8 Tighten lower mounting hardware with a 13mm
wrench and a 13mm socket.
Fig. 2.3 (Mount new Dynamo)
Remove
Reuse
Remove
Reuse
New
bracket
Bolt
Nut and
washers
Fig. 2.4 (Install belt and set the tension)