CAB INSTALLATION
11 of 35
Fig. 4.5 (Install Sealing Brushes)
Fig. 4.1 (Remove Bolts)
Fig. 4.2 (Cut Floormat)
Fig. 4.3 (Remove Pine Tree Clips)
60” Only
Cut Tabs
brushes
Step 4: (Vehicle Prep)
4.1 Remove and discard the four floorboard bolts
shown in Figure 4.1. If the mower is a 60”,
remove two additional bolts in the location shown.
4.2 See fig. 4.2. Cut the rubber tabs on the floormat at
the bolt locations as shown so that the hole is
clearly accessible.
4.3 See fig. 4.3. Remove the pine tree clips from the
floormat at the 12 locations shown.
4.4 If installing on a 60” mower, remove and save the
tilting front cover at the front of the machine.
4.5 See fig. 4.5. Install the pedal seal panel on top of
the floormat as shown. Secure to the floorpan
using the following hardware. The floorpan may
need to be lifted slightly in the front on a 60”
mower to access the center screw.
Hardware Used Qty
#10-32x3/4” Phillips Head Screw 6
#10-32 Flange Nut 6
To Next Page
Loading...