CAB INSTALLATION
12 of 35
Fig. 4.6a (Seal location on 60”)
Fig. 4.6b (Seal location on 72”)
Fig. 4.7 (Install Spacers)
Spacers
60” Only
4.6 Install self-adhesive seal around the edge of the
floor pan as shown and cut to length. Refer to
Figure 4.6a for 60” and 4.6b for 72”.
Note: placement on the 72” machine. Seal should
follow along the white line shown in fig. 4.6b.
4.7 See fig. 4.7. Insert spacer bushings into the
depressions where the floorboard bolts were
removed. (72” uses 4 spacers, 60” uses 6
spacers)
Hardware Used Qty
1/2” Long Spacer 4 or 6
4.8 See fig. 4.8. Flip the seat forward and disconnect
the OEM regulator.
Fig. 4.8 (Disconnect OEM Regulator)
Disconnect
To Next Page
Loading...