CAB INSTALLATION
13 of 35
Fig. 5.4 (Position lifting strap)
Fig. 4.9 (Install Velcro®)
Fig. 5.1 (Move Seat forward, Rotate seatback)
4.9 See fig. 4.9. Install the supplied adhesive Velcro®
as shown with white lines. Be sure to wipe down
the surfaces where the Velcro® will be adhered
and that the surfaces are at room temperature.
Apply between round seat bumpers
Apply along horizontal edge of fenders
Apply 3 sections underneath front seat support
frame member as indicated by dotted line.
Velcro® must be on the underside.
Step 5: (Cabin Installation)
5.1 See fig. 5.1. Lower the seat and slide the seat all
the way forward and use the knob on the seat to
tilt the seatback forward as much as possible.
5.2 Remove the doors from the cabin and set aside
carefully to prevent scratching the panels.
5.3 Remove the 3 bolts securing the compressor
bracket to the base of the shipping mount and cut
any zip ties holding the hoses and wire harness to
the shipping mount. Support the compressor
using a bungee cord or rope. Do not ever use the
hoses to support the compressor or damage may
occur.
5.4 See fig. 5.4. Position a lifting strap where shown
so that it sits roughly 2” in front of the b-pillar.
Lifting Strap
To Next Page
Loading...