CAB INSTALLATION
16 of 35
Step 6: (Compressor Installation)
6.1 Move compressor into location on the left side of
the engine and secure to the bracket with the
hardware removed on step 1.8. See figure 6.1.
Do not tighten hardware at this time.
Hardware Used Qty
M10x1.25x30mm Flange Bolt 3
6.2 See fig. 6.2. Install the supplied belt and tension.
Tighten all compressor pivot bolts at this time.
Note: The oil pressure sensor wire might be close
to contacting the belt. To ensure proper
clearance, the terminal might have to be bent
downward.
6.3 See fig. 6.3. Install the supplied rubber grommet
to the left side ROPS bracket.
Fig. 6.2 (Install Belt and Tension)
Fig. 6.1 (Install Compressor)
Fig. 6.3 (Install Rubber Grommet)
Bolts
Bolt
Belt
Grommet
Bend down for
clearance
To Next Page
Loading...