CAB INSTALLATION
25 of 35
Fig. 11.1 (Attach Gas Shock)
Fig. 10.4 (Filler Location)
Rubber Filler
Fig. 10.5 (Filler Location)
Rubber
Extends out
10.4 See fig. 10.4. Install the upper portion of the
rubber filler along the bottom edge of the rear
panel to locate it and then secure under the seat
and along the sides.
10.5 See fig. 10.5. The back ends of the rubber filler
should be pulled out under the cab so that they
can be attached to the fenders behind the cab with
Velcro®.
10.6 Use the rubber filler as a guide and apply
adhesive Velcro® to the tractor fenders behind the
cab.
Step 11: (Final Installation)
11.1 See fig. 11.1. Re-install doors and install gas
shocks. The end with the red tab should be
attached to the side frame of the vehicle.
11.2 Re-install the front hinged cover if working on a
60” mower.
11.3 If working on a 72” mower, inspect along the
floormat across the entire front of the vehicle and
apply a bead of black silicone to fill any gaps that
may occur.
11.4 Re-install battery cover.
To Next Page
Loading...