CAB INSTALLATION
24 of 35
Fig. 10.1 (Install Underseat Filler)
Fig. 10.3 (Install Velcro®)
Align
Back of Seat
Velcro®
Step 10: (Filler Installation)
10.1 See fig. 10.1. Raise the seat and install the rubber
underseat filler panel as shown. Start by aligning
the panel over the round rubber bumpers that the
seat rests on and work around the perimeter to
attach to the pre-installed Velcro®.
10.2 Install Velcro® around the perimeter of the
underseat filler in the areas where Velcro® was
not pre-installed using the filler as the locating
template for the Velcro®. Be sure to wipe down
the surfaces where the Velcro® will be adhered
and that the surfaces are at room temperature.
10.3 See fig. 10.3. Lower the seat, slide the seat
completely forward, tilt seat back forward, and
install adhesive Velcro® to the seat base so that it
is located up against the stamped rib as shown.
To Next Page
Loading...