CAB INSTALLATION
23 of 35
Fig. 9.2 (Assemble Cover Panel)
1/4”
Bolts
Step 8: (Functionality Testing)
8.1 Ensure that all wires and hoses are securely
fastened with cable ties to prevent any rubbing or
chaffing on sharp or hot objects.
8.2 Turn the vehicle on and check to make sure that
belts and components are not vibrating
excessively.
8.3 Bring engine to full throttle, turn on A/C blower,
and move thermostat to cold.
8.4 Check to make sure A/C is blowing cold air.
8.5 Turn engine off and allow to cool.
Step 9: (Shroud Installation)
9.1 See fig. 9.1. Assemble the front shroud panel to
the front side of the bracket installed in step 1.10.
Do not fully tighten fasteners at this time.
Hardware Used Qty
1/4-20x3/4” Flange Bolts 2
9.2 See fig. 9.2. Assemble the rear shroud panel and
cover together as shown. Leave the bolts loose at
this time.
Hardware Used Qty
1/4-20x3/4” Flange Bolts 3
9.3 See figs. 9.3a and 9.3b. Assemble the rear shroud
panel over the compressor. Secure the dynamo
wiring to the shrouds with a p-clamp. Tighten all
shroud bolts at this time. Verify that there is
clearance all around hoses and belt. Loosen
shroud and adjust, if necessary, to gain adequate
clearance.
Hardware Used Qty
1/4-20x3/4” Flange Bolts 6
1/2” P-Clamp 1
Fig. 9.1 (Install Front Shroud Panel)
Fig. 9.3a (Install Rear Shroud Panel) Fig. 9.3b (Secure Dynamo Wires with P-Clamp)
1/4”
Bolts
1/2”
P-Clamp
To Next Page
Loading...