CAB INSTALLATION
22 of 35
Fig. 7.18 (Connect Dynamo Wiring)
Fig. 7.22 (Connect Ground Wires)
Install Ring
Terminal
7.17 Route the remaining section of wires on the A/C
harness out the rear of the left side of the vehicle
so that they pass above the ROPS tube and end
near the compressor.
7.18 See fig. 7.18. Connect the female bullet terminal
on the end of the blue wire to the male bullet
terminal on the compressor.
7.19 Remove the bolt shown in figure 7.18 and install
the 3/8” ring terminal from the A/C harness onto
the bolt so that it is contacting the ear of the
compressor.
7.20 Use cable ties to secure the wire harness going to
the compressor to the hoses.
7.21 Re-install the negative terminal back onto the
battery post and tighten.
7.22 See fig. 7.22. Install the 5 ring terminals on the
black ground wires to the battery bolt and secure
with an additional nut.
Hardware Used Qty
5/16-18 Serrated Nut 1
Nut
To Next Page
Loading...