CAB INSTALLATION
21 of 35
Fig. 7.16 (Locate OEM Signal Wire)
Signal
Wire
Fig. 7.15 (Route Wiring)
7.15 See fig. 7.15. Route the remaining section of the
harness with the white connector on the end
forward from the battery area over the ROPS and
up under the seat. The harness should run across
the top of the transmission along the existing OEM
harness and end on the left side of the vehicle.
Note: Wires must be routed above the ROPS, but
below the flat area that the hood seals on when it
is closed.
7.16 See fig. 7.16. Cut the blue tape on the OEM
vehicle wire harness under the seat to expose a
male and female bullet terminal. Connect the
male bullet terminal at the end of the yellow wire
on the A/C wire harness to the female bullet
terminal on the OEM harness.
To Next Page
Loading...