CAB INSTALLATION
20 of 35
7.11 See fig. 7.11. Install the right side drive lever cover
and the previously attached vinyl filler using the
hardware removed during step 1.9.
7.12 See fig. 7.12. Once the drive lever cover hardware
has been tightened, move the lever all the way out
away from the operator, in the park position. Using
a China marker or other non-permanent marker,
make a mark on the drive handle at the top of the
filler. Wipe area with isopropyl alcohol and adhere
a piece of the supplied Velcro around handle at
the mark previously made.
7.13 See fig. 7.13. Wrap filler around drive lever
attaching Velcro on filler to Velcro on handle.
7.14 Repeat steps 7.11 through 7.13 on the left side.
Fig. 7.12 (Drive Lever Velcro)
Fig. 7.13 (Filler to Handle)
Fig. 7.11 (Drive Lever Cover & Filler)
To Next Page
Loading...