ASSEMBLY (cont.)
CUTTERHEAD GUARD
1. The cutterhead guard has a tension return spring. The tension on this spring is set at the
factory. When the guard is installed properly it should return to the fence automatically after
the work piece has passed over the cutterhead. Be sure the guard is functioning properly
every time before using the jointer. If adjustment is necessary, remove the guard and while
holding guard attachment base, rotate guard counter-clockwise to increase tension. Then
mount guard base while holding guard and mounting base to prevent from losing tension.
SEE FIG. 8
FIG 8
DUST PORT & DUST ADAPTOR
A dust port (A) is attached with the jointer to help connect it to a standard 4 inch vacuum hose. If
needed for 2-1/2” vacuum hose, you can convert it by the supplied adaptor (B). SEE FIG. 9
FIG 9
NOTE: Always use the dust port and dust collector at the same time.
To Next Page
