ADJUSTMENTS (cont.)
5. Tighten set screw (D) by hex wrench until it contacts stop (E) SEE FIG 16.
FIG 16
6. Put a square (C) on the table with one end against the fence to adjust the fence until it is
exactly 135 degrees to the table. SEE FIG 18 on the previous page.
7. Tighten set screw (H) by hex wrench until it contacts stop (G) SEE FIG 17.
FIG 17
NOTE: These positive stops enable you to quickly position the table to the 90 and 135 degree
settings.
To Next Page
