MAINTENANCE (cont.)
Note: Proper cleaning is critical to achieving a smooth finish. Dirt or dust trapped between
the cutter insert and cutterhead will slightly raise the cutter insert and make noticeable
marks on your work piece the next time you use the machine.
REPLACING THE BELT
1. Use 4MM Allen Key to loosen the screw of belt guard. SEE FIG 25.
FIG 25
2. Push the belt outward, then screw the pulley on clockwise and disassemble the belt FIG 26
FIG 26
3. Ring the belt on the drive pulley. SEE FIG 27.
FIG 27
To Next Page
