Cutting Edge 100A MPPT - Screen Interface and Settings Adjustment; Charge Controller Screen Guide; Adjusting Operational Settings

Rev 20200515 Page 7
"Innovative Renewable Energy Solutions"
Home Screen:
Default display which shows the baery voltage, if the solar panels are charging,
and if the load output is engaged.
From the home screen, short press “menu” to view the status of all parameters.
When you get to a seng you want to change, long press “menu” for 3 seconds to enter “edit mode”. Aer
the seng is adjusted, to save: short press “menu” or just wait for the screen to me out.
PV OFF:
The voltage at which solar charging will be disconnected. PV OFF should be the
maximum voltage you want your baery/baeries to be charged. (Typ.
Note: this MUST be modied for LiFePO4 baeries!! Refer to your baery speci-
caons!
LOAD ON (Voltage):
The voltage at which the load output will be engaged (if allowed by me seng).
LOAD OFF:
The voltage at which the load output will be disconnected. This is a protecve
seng to prevent the baery from overdischarging.
LOAD ON (Time):
The me at which the load output can be engaged. 24h means the load will al-
ways be on as long as the voltage doesn't drop below “LOAD OFF”. 1-15h means
the load output will be engaged for this many hours aer the charge controller no
longer detects the solar panel (sunset). 0h acvates the “dusk to dawn” seng;
load will be set to engage at dusk and disengage at dawn.
b1, b2, b3, b4 These are preset sengs and can be disregarded.
The other displays are status indicators/parameters.
SCREEN GUIDE:
Sengs that are adjusted will be automacally saved, even if power is removed.