Cutting Edge 100A MPPT User Manual

Rev 20200515 Page 8
"Innovative Renewable Energy Solutions"
PROBLEM CAUSE SOLUTION
Charge icon is not on when
it’s sunny
Solar panel polarity (+/-) reversed
Solar panel not connected
Solar panel defecve
Wire(s) cut or disconnected
Use a mulmeter to verify connuity and
voltage output from solar panel(s)
Load icon o Mode seng wrong
Baery low
Refer to load sengs earlier in this docu-
ment
Load icon ashing slowly Overload
Short circuit on load output
Reduce load output or correct short circuit.
Try again aer 1 minute.
No display on screen Baery voltage too low or baery
polarity (+/-) incorrect
Check baery and / or connecon
Odd characters on screen /
incorrect voltage displayed
(veried with mulmeter)
Defecve charge controller Contact Support@CungEdgePower.com
TROUBLESHOOTING:

Cutting Edge 100A MPPT Specifications

General

Brand	Cutting Edge
Model	100A MPPT
Category	Controller
Language	English