Page 8 of 34
General Installation Requirements
The installation should only be carried out by a GAS SAFE
Registered fitter and in accordance with national and local
regulations for both gas & electricity.
The appliance is intended for decorative purposes only.
Foreign objects should not be placed on to the appliance or otherwise disturb
the fuel bed. Debris from any source, or soot formed, should be removed
from the appliance, see ‘Appliance Cleaning Instructions’.
The appliance may emit a slight smell for a period of time after
commissioning. This is quite normal and any odours will disperse within a
few hours of operation.
The pilot light and flame sensing device installed to the appliance are also
atmospheric sensing devices. The device is not adjustable and must not be
disabled. If evacuation of combustible products is interrupted the device
shuts down both the main burner and pilot light. In the event of a single
shut down, do not attempt to re-light the pilot within three minutes, once
three minutes have passed the appliance can be re-started in accordance
with ‘Appliance Start Up / Shut Down Instructions’. In the event of repeated
shut downs, do not use the appliance and have the flue and appliance
checked by a CORGI Engineer. If any part of the pilot assembly needs to be
replaced, including the pilot burner, thermocouple, electrode and injector the
complete assembly must be replaced with an original manufacturer's pilot
assembly by a CORGI Engineer.
Warning – Do not adjust the system.
Warning – Do not disable the flame sensing device.
Warning – Use only OEM parts.
The installation should only be carried out by a GAS SAFE Engineer and in
accordance with national and local regulations for gas. The installation must
also be in accordance with relevant parts of local and national building
regulations. For the Republic of Ireland, reference should be made to IS813
and ICP3 and any guidance notes from Bord Gais.
Read the instructions carefully before proceeding. Failure to do so could
result in an unsafe installation and may invalidate the warranty.
Failure to have the fire fitted by a qualified person will invalidate the
Warranty, and CVO Fire will not accept any claims for incorrect
installation.
To Next Page
Loading...
