CyberData Corporation
3 Justin Court, Monterey, CA 93940
www.cyberdata.net
P 831.373.2601 | F 831.373.4193
RING CENTRAL CONFIGURATION GUIDE: V3 PAGING SERVER
Doc. 931042C Page 10
Features
• Voice prompted paging menu
• Up to 100 configurable, password controlled zones or “paging groups”
• DTMF zone selection for IP zone control
• DTMF pass-through for analog zone control
• Dry relay contact closure for page initiation
• Delayed paging
• Web-based graphical user interface or TFTP/HTTP remote configuration
• RCA Line Level input connection for background music
• RCA Line Level output (10k Ohms @ 2 VPP)
• Page Port output (600 Ohms @ 5 VPP)
Caveats
Please be advised only multicast-supported IP phones may be aggregated into a multicast paging
group. Currently, other than Polycom IP Phones capable of running UC Software version 4.0.0
and higher, RingCentral sells the following models tested for compatibility through a CyberData
reseller:
• Cisco SPA 514G
• Cisco SPA 525G
These models support up to 2 multicast groups (multicast address and port number) when
running firmware version 3.2.2. Refer to Cisco documentation for configuration details.
If you are comfortable with manual configuration, you may want to review the complete list of
compatible multicast-supported IP phones on our website here:
http://www.cyberdata.net/products/voip/digitalanalog/pagingserverv3/documentation/930631A_
v3_paging_server_compatibility_guide.pdf
A complete list of IP phones tested with RingCentral is published in RingCentral Knowledge
Article 3619.
To Next Page
Loading...