CyberData Corporation
3 Justin Court, Monterey, CA 93940
www.cyberdata.net
P 831.373.2601 | F 831.373.4193
RING CENTRAL CONFIGURATION GUIDE: V3 PAGING SERVER
Doc. 931042C Page 23
6.0 Configuration Procedure: Nightringer
What is a Nightringer?
The CyberData V3 Paging Server offers a secondary SIP extension called Nightringer in
addition to the primary extension used for paging.
The Nightringer plays a customizable ring tone when an incoming call is detected. The
Nightringer extension can be added to ring groups for simultaneous ringing. When added to a
ring group, the Nightringer will ring until a ring group member picks up the call. The
Nightringer stops ringing when the call is answered by a ring group member or when the caller
disconnects before a ring group member picks up the call. The Nightringer extension cannot
answer a call.
Provisioning Nightringer with RingCentral
Provisioning a Nightringer extension with RingCentral requires creating a user and provisioning
an IP phone in the same manner as the paging extension in Section 5.0 “Configuration
Procedure: Paging Extension.” Therefore, if you plan to use the Nightringer extension you will
need a total of two RingCentral users associated with IP Phones.
It is important to note the Paging Extension and Nightringer Extension must use separate sets of
SIP extension parameters. That is, each must be assigned their own SIP extension. The
Nightringer cannot use the same provisioning information already in use by the Paging
Extension (and vice versa).
To be clear, when integrating with RingCentral the Nightringer extension must be provisioned as
an IP phone rather than a Paging Device in order to allow the Nightringer to ring.
If the Nightringer is provisioned and registered as a Paging Device, the Nighringer will only ring
for 2 seconds before the call is cancelled by the RingCentral server. Thus, it is necessary to
provision the Nightringer as an IP phone for full functionality. Please consult with RingCentral
for costs associated with IP phone provisioning on your account.
Note: For voice paging, provision the paging extension as an IP phone associated with a
user extension by following the instructions in Section 5.0 “Configuration Procedure:
Paging Extension.
Once you have created a user and associated an IP phone for the Nightringer extension, proceed
to Configure the Nightringer SIP Parameters.
To Next Page
Loading...