Notice
The SE500CP is a measuring device intended for use in SMT production environment. Use of this
equipment in a manner not specified in the operating instructions may impair safe operation.
Information in this document is subject to change without notice. CyberOptics Corporation may make
improvements or changes in the products described in this publication at any time.
Trademarks
The following are trademarks or registered trademarks in the United States and other countries:
CyberOptics and
SE500CP are (owned by CyberOptics Corporation); Windows (owned by Microsoft
Corporation).
Warranty, License, and Terms of Sale
The warranty, software license and other terms and conditions of sale covering CyberOptics products are
set forth in CyberOptics Standard Terms and Conditions of Sale and License available at
www.cyberoptics.com or by calling CyberOptics at 1-800-526-2540 and requesting a copy.
SE500CP Hardware Manual
Part Number 8015899, Revision E
November 2013
©2013 CyberOptics Corporation. All Rights Reserved.
To Next Page
Loading...