CyberPower PDU31 Series User Manual

23
Web Interface
Intelligent PDU User Guide
Item
Definition
Low Load Threshold
Set the value for the total current on the PDU that will signal a low
load warning. Must be lower than Near Overload Threshold.
Outlet Restriction**
When load current exceeds the corresponding threshold, no
outlets will be allowed to turn on.
*None: Users can turn on an outlet even if the device is in Near
Overload or Overload state.
*On Near Overload: Users cannot turn on an outlet when the
device is in Near Overload or Overload state.
*On Overload: Users cannot turn on an outlet when the device is
in Overload state.
Power Restore
Peak Load
Reset the peak load to zero.
Energy
Reset the energy to zero.
ColdStart Configuration
ColdStart State
*Previous State: Outlets will return to the same state (on or off)
they were in prior to the PDU turning off. The ColdStart Delay
setting will apply when the PDU resumes power.
*All On: All outlets will turn on when power is restored to the PDU.
ColdStart Delay
*Instant: Outlets will be turned on immediately when power is
restored to the PDU.
*Wait: Outlets will be turned on according to this setting when
power is restored to the PDU.
*Never: Outlets will not be turned on when power is restored to the
PDU.
System Configuration
Idle Time
The PDU LCD screen will turn off automatically after it remains
idle for the selected period of time.
**For some models, the Outlet Restriction only shows in the Bank Manager Page.

CyberPower PDU31 Series Specifications

General

Brand	CyberPower
Model	PDU31 Series
Category	Power distribution unit
Language	English