36
Installing and Removing the Infant Car Seat
Installing with Base Using Lap/Shoulder Belts
6. On the Buckle side, rst lift up on the
Shoulder Belt to remove slack in the
Lap Belt. Then remove slack from the
Shoulder Belt on the opposite side.
Remove slack from the vehicle belts,
being careful not to overtighten. The
SafeLock Belt Tensioner will tighten the
system fully.
7. Press down on the sides of the
SafeLock Belt Tensioner until an audible
CLICK is heard and the Belt Lock
Indicator turns GREEN. If Belt Tensioner
does not lock, try loosening the vehicle
belt slightly, then try to close again.
yy
uu
To Next Page
Loading...
