48
Installing and Removing the Infant Car Seat
Installing the Infant Car Seat Only Using Lap/Shoulder Belts (Alternate)
3. LOCK your vehicle Lap/Shoulder Belt.
Refer to your vehicle Owner's Manual for
how your vehicle Lap and Shoulder Belt
locks.
In many vehicles, you can switch the
Shoulder Belt Retractor into locking mode
by pulling the Shoulder Belt out all the way.
Check the vehicle owner's manual to see
how your system locks.
To check if the vehicle belt is locked, after
you install the Infant Car Seat, pull up
rmly on the Lap Belt between the Belt
Guides. The belt should remain tight if the
vehicle system is locked.
4. Push Infant Car Seat rmly into vehicle
seat, pressing down near the Buckle Strap
between the child’s legs AA, while removing
slack from Lap Belt BB. Repeat for Shoulder
Belt.
5. Make sure that vehicle belt buckle and
hardware DO NOT INTERFERE with the
Infant Car Seat.
tt
ee
AA
BB
rr
To Next Page
Loading...
