Page 2 of 7
www.cybexintl.com
Disconnect power source
Unplug the power cord from the power outlet.
WARNING: Shock and electrocution hazard
• Unplug unit and let sit 10 minutes before cleaning or performing maintenance
• Electrical charge can remain in unit after unplugging
• Keep water and liquids away from electrical parts
NOTICE: Component damage
Wear an ESD grounding strap during this procedure. Connect ESD grounding strap to
frame bolts or unpainted metal of frame. If ESD grounding strap is not available, touch
frame bolts or unpainted metal of frame before handling any electronics.
Remove back cover
Remove the four screws securing the back cover to the console assembly using a Phillips
screwdriver.
3
2
1
Description Qty
1 Console Assembly 1
2 Back Cover 1
3 Screws 4
Remove access cover
1. Remove the two screws securing the access cover to the handset using a Phillips screwdriver.
A/V models
3
2
4
5
1
Description Qty
1 Connector J6 1
2 Headphone Jack Cable 1
3 Headphone Jack Cover 1
4 Screws 2
5 Handset 1
To Next Page
Loading...
Need help?
General
