3. If there's an existing custom program on the 700C Cycle and 700R Recumbent Cycle, it is
displayed; if there isn't, the workout graph is blank.
Now you choose the setting for the first segment of the program. Press the up arrow to
raise the setting or the down arrow to lower it. When the height is correct, press Enter to
move to the next segment. The display scrolls to the left as you move through the
program.
4. Repeat this process for each segment of the program: use the arrow keys to set the
height, then press Enter to move to the next segment.
5. If the program has less than 60 segments, enter a segment with a level of 0 to end the
program.
If you make a mistake while defining the program, you can press Advanced
Options to move back to a previous segment and correct it.
6. When you're done, press Clear to save the program and leave Setup Mode.
Using a Custom Pr
ogram
1. Get on your 700 series cycle and start pedaling to activate the console.
2. Press the Advanced Options key. If you press a key somewhere else on the console, an
arrow will point toward the program keys, instructing you to select one.
Press Advanced Options until the top display reads “Custom.” Press Enter.
3. The display will show the default workout length. You can change this using the up and
down arrow keys, or use the keypad to type the number of minutes you want to work out.
If you try to enter a time longer than the maximum for this 700 series cycle, it won't
accept your entry. Press Enter.
The 700C Cycle and 700R Recumbent Cycle will take the workout length you enter and
divide it by the number of segments in your custom program to determine the length of
each segment. For example, if you have a program with 15 segments, and enter a workout
length of 30 minutes, each segment is 2 minutes long.
4. Press Start.
While you're pedaling, the 700C Cycle and 700R Recumbent Cycle operates just like it does
during one of the preset programs. The console shows statistics about your workout, and you
can raise or lower the overall level of the program, or pause during it, all as described in
Chapter 3.
Cybex 700C Cycle and 700R Recumbent Cycle Owner’s Manual
Page 4-6
To Next Page
Loading...
Need help?
General
