CYBEX 8800 User Manual

Product Number 8800/8810/8830/8840 Owner’s Manual
4-4
7. Install weight plate decals.
NOTE: You have the option to use pounds, kilograms or both.
Slowly and carefully peel off back side of decal. See Figure 6. A.
NOTE: When peeling off back cover, make sure that the decals
remain attached to the front sticker.
Align holes in decal with appropriate holes in weight stack. B.
NOTE: Do not allow the adhesive to touch weight stack at
this time.
Insert a guide pin through each hole of the template. C.
NOTE: A guide pin can be anything that fi ts through the weight stack hole, such as a weight stack
selector pin.
Carefully align decal and rub it onto weight plates. D.
Carefully remove front side, leaving decals adhering to weight plates. See Figure 7. E.
Carefully align weight plates over guide rods and slowly lower each weight plate. Q.
NOTE: When installing weight plates, position plates so wide edges of bushings face upward and narrow
edges of bushings face downward. See Figures 5a and 5b.
NARROW bushing edge
WRONG
WIDE bushing
edge faces upward
CORRECT
NOTE: The narrow bushing
edge must face downward.
Figure 5a
Figure 5b
Figure 6
Front
Back
Repeat step 6Q for each weight plate.R.
Carefully slide top weight (removed in step 6J) over guide rods.S.
Figure 7
Standard
Weight
Stack
Pounds
Kilograms
Kilograms
Pounds
Graduated
Weight
Stack

CYBEX 8800 Specifications

General

Brand	CYBEX
Model	8800
Category	Home Gym
Language	English