B. Using a Phillips head screwdriver, tighten
the six screws and six washers securing
each side cover. See Figure 4.
19. Secure the linkage arms.
A. Attach each linkage arm to each crank
(removed in step 5). NOTE: If you need
a new linkage cap then order kit number
600AK012.
B. Place a drop of loctite (F) to threads on
SHCS and into the shaft where the SHCS
will be tightened into.
C. Using a 3/16” Allen wrench, reinstall the
SHCS, washer, cap and spacer (removed
in step 5A). See Figure 3
20. Attach the access cover.
A. While being sure not to pinch any cables,
hold the access cover in place. See Figure 2.
B. Using a Phillips head screwdriver, tighten the
four screws and washers securing the access
cover. See Figure 2.
21. Test unit for proper operation.
Cybex
®
and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer
®
and its mark are registered trademarks of Cybex International, Inc.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 • www.cybexinternational.com • techhelp@cybexintl.com
techpubs@cybexintl.com • Copyright © 2008, Cybex International, Inc. All rights reserved • 600A-342 C • March 2008
To Previous Page
Loading...
Need help?
General
