6
Cybex FT-325 Owner’s Manual
SECURING EQUIPMENT
Do not use machine until it is properly anchored.
The machine has holes in the feet, which allow for ease in anchoring to the oor. All anchoring holes
must be used to maximize stability. Cybex strongly recommends equipment be secured to a solid,
level surface to eliminate rocking, tipping, or falling over due to incorrect usage and misuse.
The solid, level surface should not deviate more than 1/8” over a 10’ distance or as dened and
required by local building and architectural codes.
Anchoring of equipment must be completed by a qualied licensed contractor.
Anchoring holes are provided on the feet of the frame. All anchoring locations must be used when
anchoring the equipment to the oor.
Due to the wide variation of ooring on which machines may be anchored or installed, verify
anchoring method and anchoring fasteners with a qualied and licensed contractor.
A minimum pull out force of 220 lbs/100 kgs is required for each anchor position.
PROPER USAGE
Use machine only as described in the manual. Failing to follow proper instructions may result in injury.
WARNING: Serious injury or death could occur if the following warnings are not
enforced: DO NOT Lean Against or Pull On the framework, weight stack,
or any component, whether machine is at rest or in use. Inappropriate or
improper use may result in injury to users or third parties (bystanders)
STANDARD COMPLIANCE
Cybex products meets applicable ASTM and EN Standards.
To Next Page
Loading...
Need help?
General
