5
Cybex FT-325 Owner’s Manual
Do not install equipment on an uneven surface!
DANGER !
Death or serious injury will occur if the
following requirements are not met:
Cybex is not able to anchor the equipment due to local building codes.
The owner is responsible for the actual anchoring of equipment.
Consult with a professional contractor.
Use fasteners having a minimum of 500 lbs. tensile capacity -- Cybex
recommends 3/8” grade 2 bolts or better.
If legs/frame does not contact surface, DO NOT pull down with
anchors. Shim any leg or frame not in contact with surface using at
washers.
Ensure that all users are properly trained on how to use the equipment.•
Verify there is enough room for safe access and operation of the equipment. Spacing •
requirements for each piece of equipment can be found in the Assembly section of this manual, on
the assembly instructions during setup, and on the cybexintl.com website.
Perform regular maintenance checks on the equipment as detailed in the Maintenance section of •
this manual. Inspect all areas most susceptible to wear, including, (but not limited to) cables,
pulleys, belts, and grips.
Immediately replace worn or damaged components. If unable to immediately replace worn or •
damaged components then remove from service until the repair is made.
Use only Cybex supplied components to maintain/repair the equipment.•
Keep a repair log of all maintenance activities.•
Display the Facility Safety Sign so it is visible and prominent.•
Safety Guidelines And Practices
Cybex recommends that all tness equipment be used in a supervised area. It is recommended that
the equipment be located in an access controlled area. Control is the responsibility of the owner. The
extent of control is at the discretion of the owner.
It is the responsibility of the purchaser/user of Cybex products to read and understand the owner’s
manual, and warning labels; as well as instruct all individuals, whether end users or supervising
personnel, on proper usage of the equipment.